基于新型二维核函数动态X参数的功放建模

doi:10.11772/j.issn.1001-9081.2017.08.2421

计算机应用 ›› 2017, Vol. 37 ›› Issue (8): 2421-2426.DOI: 10.11772/j.issn.1001-9081.2017.08.2421

• 应用前沿、交叉与综合 • 上一篇下一篇

基于新型二维核函数动态X参数的功放建模

南敬昌, 崔洪艳

辽宁工程技术大学电子与信息工程学院, 辽宁葫芦岛 125105

收稿日期:2017-01-17 修回日期:2017-03-04 出版日期:2017-08-10 发布日期:2017-08-12
通讯作者: 崔洪艳
作者简介:南敬昌(1971-),男,河南滑县人,教授,博士,主要研究方向:射频电路与系统、电路系统与电磁仿真、信号处理与信息编码;崔洪艳(1993-),女,辽宁抚顺人,硕士研究生,主要研究方向:射频功放非线性分析、射频电路设计。
基金资助:
国家自然科学基金资助项目（61372058）；辽宁省高校重点实验室项目（LJZS007）。

Modeling of power amplifier based on dynamic X-parameter of new two-dimensional kernel function

NAN Jingchang, CUI Hongyan

School of Electronic and Information Engineering, Liaoning Technical University, Huludao Liaoning 125105, China

Received:2017-01-17 Revised:2017-03-04 Online:2017-08-10 Published:2017-08-12
Supported by:
This work is partially supported by the National Natural Science Foundation of China (61372058),the Key Laboratory Project of Higher Education of Liaoning Province (LJZS007).

摘要/Abstract

摘要： 为了更准确地描述带有记忆效应的射频（RF）功放特性，基于传统的动态X参数模型，结合功放长期记忆效应以及短期记忆效应机理，提出一种新型动态X参数功放建模方法。新模型保留X参数模型的静态核函数，利用双记忆路径模型提取出表征记忆效应的非线性函数，替换动态核函数。采用输出信号为幅度与频率双变量的新型反馈（FB）结构，引入时变频率变量而简化动态核函数为二维核函数。使用MW6S010N设计功放并建模，由仿真可知，新模型在单音大信号及码分多址（CDMA）信号激励下，均能正确表征功放特性，归一化均方误差（NMSE）较静态X参数模型、传统动态X参数模型以及前馈（FF）结构X参数模型分别减少8.0 dB、6.3 dB、2.5 dB。结果表明该模型能够更加准确拟合带有非线性记忆效应功率放大器的特性。

关键词: 二维核函数, 动态X参数, 反馈结构, 记忆效应, 功率放大器, 行为模型

Abstract: In order to accurately describe the characteristics of Radio Frequency (RF) power amplifier with memory effect, a new dynamic X-parameter amplifier modeling method based on traditional dynamic X-parameter model was proposed by combining with long-term memory effect and short-term memory effect. The new model preserves static kernel function of X-parameter model. A nonlinear function of memory was extracted by using the two-memory path model to replace dynamic kernel function. A novel FeedBack (FB) structure was proposed in which the output signal is a bivariate of amplitude and frequency, and the time-varying frequency variable was introduced to simplify the dynamic kernel function as a two-dimensional kernel function. The power amplifier was designed and modeled by the MW6S010N transistors. Simulation results indicate that the new model can correctly represent the characteristics of power amplifier with the excitation of single-tone large signal and Code Division Multiple Access (CDMA) signal. The Normalized Mean Square Error (NMSE) of the proposed method was decreased by 8.0 dB, 6.3 dB and 2.5 dB, respectively, in comparison with static X-parameter model, traditional dynamic X-parameter model and FeedForward (FF) structure X-parameter model. It is proved that the proposed model can more accurately fit the characteristics of power amplifier with nonlinear memory effect.

Key words: two-dimensional kernel function, dynamic X-parameter, FeedBack (FB) structure, memory effect, power amplifier, behavior model

中图分类号:

TN722.7

南敬昌, 崔洪艳. 基于新型二维核函数动态X参数的功放建模[J]. 计算机应用, 2017, 37(8): 2421-2426.

NAN Jingchang, CUI Hongyan. Modeling of power amplifier based on dynamic X-parameter of new two-dimensional kernel function[J]. Journal of Computer Applications, 2017, 37(8): 2421-2426.

参考文献

[1] 袁晓辉.记忆非线性功率放大器行为模型及其数字预失真[D].成都:西南交通大学.2015:2-8. (YUAN X H. Behavioral modeling and digital predistortion of nonlinear power amplifiers with memory effects[D]. Chengdu:Southwest Jiaotong University, 2015:2-8.)
[2] 林茂六.射频微波功放器件非线性记忆效应测量与行为建模技术的新进展[J].电子测量与仪器学报,2014,28(2):113-122. (LIN M L. New progress on nonlinear measurement and behavioral modeling for RF power amplifiers with memory effects[J]. Journal of Electronic Measurement and Instrumentation, 2014, 28(2):113-122.)
[3] JANG H, ZAI A, REVEYRAND T, et al. Simulation and measurement-based X-parameter models for power amplifiers with envelope tracking[C]//MTT' 13:Proceedings of the 2013 IEEE MTT-S International Microwave Symposium Digest. Piscataway, NJ:IEEE, 2013:1-4.
[4] 苟元潇,傅佳辉,林茂六,等.基于矢量测量的射频微波器件非线性参数化行为建模技术评述[J].仪器仪表学报,2013,34(6):1319-1329. (GOU Y X, FU J H, LIN M L, et al. Review of nonlinear behavioral modeling for RF microwave devices based on vectorial measurement[J]. Chinese Journal of Scientific Instrument, 2013, 34(6):1319-1329.)
[5] VERSPECHT J, HORN J, BETTS L, et al. Extension of X-parameters to include long-term dynamic memory effects[C]//MTT' 09:Proceedings of the 2009 IEEE MTT-S International Microwave Symposium Digest. Piscataway, NJ:IEEE, 2009:741-744.
[6] VERSPECHT J, HORN J, ROOT D E. A simplified extension of X-parameters to describe memory effects for wideband modulated signals[C]//ARFTG 2010:Proceedings of the 201075th Automatic Radio Frequency Techniques Group Microwave Measurement Symposium. Piscataway, NJ:IEEE, 2010:132-136.
[7] VERSPECHT J, ROOT D E, NIELSEN T. Dynamic X-parameters:behavioral modeling in the presence of long term memory effects[C]//GeMiC 2012:Proceedings of the 7th German Microwave Conference. Piscataway, NJ:IEEE, 2012:1-4.
[8] SOURY A, NGOYA E. Handling long-term memory effects in X-parameter model[C]//MTT' 12:Proceedings of the 2012 IEEE MTT-S International Microwave Symposium Digest. Piscataway, NJ:IEEE, 2012:1-3.
[9] 田秀华,王振霞,南敬昌.基于功放记忆效应的动态X参数模型的研究[J].计算机应用研究,2016,33(1):71-74. (TIAN X H, WANG Z X, NAN J C. Research of dynamic X-parameter model based on memory effects of power amplifier[J]. Application Research of Computers, 2016, 33(1):71-74.)
[10] ESSAADALI R, JARNDAL A, KOUKI A B, et al. A new GaN HEMT equivalent circuit modeling technique based on X-parameters[J]. IEEE Transactions on Microwave Theory and Techniques, 2016, 64(9):2758-2777.
[11] 李久超,南敬昌,刘元安.通信系统中功率放大器记忆效应的研究[J].计算机仿真,2010,27(7):342-345. (LI J C, NAN J C, LIU Y A. Study of memory effects on power amplifier for communication system[J]. Computer Simulation, 2010, 27(7):342-345.)
[12] MAZIERE C, SOURY A, NGOYA E, et al. A system level model of solid state amplifiers with memory based on a nonlinear feedback loop principle[C]//Proceedings of the 35th European Microwave Conference. Piscataway, NJ:IEEE, 2005:853-856.
[13] NGOYA E, MONS S. Progress for behavioral challenges:a summary of time-domain behavioral modeling of RF and microwave subsystems[J]. IEEE Microwave Magazine, 2014, 15(6):91-105.
[14] QUINDROIT C, NGOYA E, BENNADJI A, et al. An orthogonal lookup-table decomposition for accurate IMD prediction in power amplifier with memory[C]//MTT' 08:Proceedings of the 2008 IEEE MTT-S International Microwave Symposium Digest. Piscataway, NJ:IEEE, 2008:1437-1440.
[15] GUSTAVSEN B. Improving the pole relocating properties of vector fitting[J]. IEEE Transactions on Power Delivery, 2006, 21(3):1587-1592.

基于新型二维核函数动态X参数的功放建模

Modeling of power amplifier based on dynamic X-parameter of new two-dimensional kernel function

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 5

编辑推荐

Metrics

[1]	南敬昌, 樊爽, 高明明. 基于负载牵引和记忆效应的X参数的功放建模[J]. 计算机应用, 2018, 38(10): 2982-2989.
[2]	袁亚男, 王鹏, 刘峰. 多尺度量子谐振子算法性能分析[J]. 计算机应用, 2015, 35(6): 1600-1604.
[3]	刘鲁川孙凯. 享乐型信息系统用户采纳的理论模型及实证检验[J]. 计算机应用, 2011, 31(11): 3120-3125.
[4]	彭艾黄岚王忠义王成. 无线传感器网络LEACH协议的Petri网模型及性能分析[J]. 计算机应用, 2009, 29(4): 1059-1063.
[5]	何红洲周明天. 基于背景的个性化客户行为模型研究[J]. 计算机应用, 2009, 29(12): 3283-3286.