计算机应用 ›› 2021, Vol. 41 ›› Issue (10): 3049-3055.DOI: 10.11772/j.issn.1001-9081.2020121973

所属专题: 前沿与综合应用

• 前沿与综合应用 • 上一篇    下一篇

双向航道集装箱港口船舶调度优化算法

郑红星1,2, 朱徐涛1, 李振飞2   

  1. 1. 大连海事大学 交通运输工程学院, 辽宁 大连 116026;
    2. 大连海事大学 航运经济与管理学院, 辽宁 大连 116026
  • 收稿日期:2020-12-15 修回日期:2021-04-30 出版日期:2021-10-10 发布日期:2021-07-14
  • 通讯作者: 郑红星
  • 作者简介:郑红星(1971-),男,河北迁安人,教授,博士,主要研究方向:物流系统优化与仿真;朱徐涛(1996-),男,浙江宁波人,硕士研究生,主要研究方向:物流系统优化与仿真;李振飞(1995-),男,山东东营人,硕士研究生,主要研究方向:物流系统优化与仿真。
  • 基金资助:
    国家自然科学基金资助项目(71872025)。

Optimization algorithm of ship dispatching in container terminals with two-way channel

ZHENG Hongxing1,2, ZHU Xutao1, LI Zhenfei2   

  1. 1. College of Transportation Engineering, Dalian Maritime University, Dalian Liaoning 116026, China;
    2. School of Maritime Economics and Management, Dalian Maritime University, Dalian Liaoning 116026, China
  • Received:2020-12-15 Revised:2021-04-30 Online:2021-10-10 Published:2021-07-14
  • Supported by:
    This work is partially supported by the National Natural Science Foundation of China (71872025).

摘要: 针对拥有双向航道的集装箱港口中船舶进出港所遇到的会遇和追越等问题,提出了一种重点考虑服务规则的新型船舶调度优化算法。首先,同时考虑双向航道的现实约束和港口夜航的安全规定;然后,构建了以所有船舶在港总等待时间最小为目标的混合整数规划模型来得出最佳的船舶进出港次序;最后,设计了嵌入聚合策略的分支切割算法对模型进行求解。通过数值实验可知,运用嵌入聚合策略的分支切割算法所得结果与下界值的平均相对偏差为2.59%。同时,与模拟退火算法与量子差分进化算法的对比结果表明,所提的分支切割算法所得的目标函数值相较于两个对比算法所得目标函数值分别减少了23.56%和17.17%,验证了该算法的有效性。在用所提算法得到方案的敏感性分析中比较了不同抵港安全时间间隔和船舶类型比例对方案结果的影响,为双向航道集装箱港口的船舶调度优化提供了决策支持。

关键词: 双向航道, 集装箱港口, 船舶调度, 嵌入式聚合, 分支切割算法

Abstract: For the problems of encountering and overtaking in the process of in-and-out port of ships in the container terminals with two-way channel, a new ship dispatching optimization algorithm focusing on the service rules was proposed. Firstly, the realistic constraints of two-way channel and the safety regulations of port night sailing were considered at the same time. Then, a mixed integer programming model with the goal of minimizing the total waiting time of ships in the terminal was constructed to obtain the optimal in-and-out port sequence of ships. Finally, the branch-cut algorithm with embedded polymerization strategy was designed to solve the model. The numerical experimental results show that, the average relative deviation between the result of the branch-cut algorithm using embedded polymerization strategy and the lower bound is 2.59%. At the same time, compared with the objective function values obtained by the simulated annealing algorithm and quantum differential evolution algorithm, the objective function values obtained by the proposed branch-cut algorithm are reduced by 23.56% and 17.17% respectively, which verifies the effectiveness of the proposed algorithm. The influences of different safe time intervals of ship arriving the port and ship type proportions were compared in the sensitivity analysis of the scheme obtained by the proposed algorithm, providing the decision and support for ship dispatching optimization in container terminals with two-way channel.

Key words: two-way channel, container terminal, ship dispatching, embedded polymerization, branch-cut algorithm

中图分类号: